My workspace
a prototype panel
I did a lot of this
Sides of the control panels
The bottom piece
Testing the height
Unfinished, but looking good.
Note the way this is mounted
Glue and Screws everywhere
Routed out for T-molding
DSC_3600.JPG
DSC_3602.JPG
Tabletop after a sanding
Looking great
Routed out for T-molding
Applying the first coat of finish
My plywood was a little fuzzy
first coat
Second coat
It's much nicer after a second coat
That plexiglass looks good!
Wiring up my panels
Almost done!
Just a few more holes for electronics
Speakers go here
Vents go here
Player 1 speaker/volume control
Mounted and good to go
Cutting out a vent on the bottom
Not too bad...
And one more big hole for the monitor
Cleaning up some chips with wood filler
Mounting the monitor
very nice
Note the 4 wooden pegs the monitor si...
Laying out the electronics
The hinge for the tabletop
The final piece, 1/4" plexiglass top
Fabrication Complete!
Now for menus
And electronic adjustments...
and more menus
P1 control panel
Leg Levelers
A view of the underside. Hand carved...
Powers supply and hard drive
Motherboard
Out fan
Note the in vent and out vent
P1 speaker, mounted
My KeyWiz, a mess, but functional :D
Power cords a plenty